The shape and overall shape of the handle still need to be adjusted.

One is that the shape of the handle should be bigger, and the place where the handle is held should not be nearly circular in cross section, which has been mentioned by some people and is easy to slip. The other is that if you carry too much takeout, the pressure is strong and it is easy to hurt your fingers for a long time.

The other is that considering the actual size, the octopus-shaped bottom will be relatively large. If you carefully observe that many riders' electric cars will be equipped with take-out hardware, the current shape is not suitable for hanging on electric cars, and the flat whole can be better hung on electric cars. And you can see that the handle for lifting heavy objects you investigated is basically a straight board style, so there is no turning point in the power transmission when lifting heavy objects, although the current one is for the purpose of storing the belt, it is easy to crack if the strength of the place like this turning point is used for a long time, so it is better to directly make it into an external storage. Reduce the volume.

There is also the use of semicircular slot buckle is not convenient, it would be better to make a sliding switch directly.

The first handle, communicate. First, see that you have made a semicircular groove on your outer surface. What is this for or is it pure decoration? If it is pure decoration, then its shape should be optimized. Second, at present, you have treated the part of your hand into a state close to a circular cross section. Many riders wear gloves and sweat in summer. The cross section shape still needs to lean on a rectangular state and is not easy to slip. Three, if you show the inside, you can draw a complete shell, and you can leave the structure of reinforcing ribs, screw columns and so on alone.

1. At present, the quantity is a little small; 2. The overall typesetting and font can be optimized by looking for a concise portfolio. 3. The second work feels that the color matching can refer to 3C products and then color matching. If there is time, the modeling details can also be optimized. For example, some components, such as directly extruded parts, even if the edges are chamfered and then rounded, it will also appear that this product details more. The whole is quite good. I like the third work very much. come on, come on

Perfect

full of personality

The work is good.