I don't know how much the cost of this product is higher than that of similar products. moreover, do you really think this shape looks good? your grille might as well be reduced to the center. you have to turn an angle and it is too fragmented.

I looked at the opinions of fresh graduates... Do not spray
There is no problem with this mold opening. If there is a problem, you can explain your company's structural designer lj.
Just need to optimize the appearance according to the parts, do subtraction.

Personally, I think the grid problem is still easy to solve, but the final effect will be poor. The main problem is that the control is divided into two parts. One of them is at the air outlet, so the requirements for wiring, heat insulation, heat dissipation and so on are higher. It is estimated that the factory will not be able to do it

If the structure cannot be made, it is really funny to scold the appearance. Why don't you say your technology is not good?

It is a waste of time. The mold cannot be opened unless it is printed in 3D.

How to open the mold and how to fix the horizontal bars in the middle?

It's beautiful, but I didn't understand how to make a model.

Beauty

I would like to ask how this mold grid is produced, where and how to connect it.

Modeling is not simple oh ~ figure a closed!!!

Look good!

Very good

True personality, I like it

Beautiful!!!