Lntelligent

I didn't expect the new year to be such a beginning, too south!

However, it is not all bad news. I learned of the IF award notice some time ago and took this opportunity to sort out my works. There was also a period of time between the last release of the work, and the time was occupied by various trivial things. Finally, on this special day, I wish you all good health!

Name: Beisi Vehicle Inflator
Software: rhino keyshot ps
Status: Mass production and listing
Function: Intelligent preset tire pressure does not need to manually adjust the number of tire pressure, and automatically detects the suitable tire pressure value of the model. Built-in smart sensor chip, one button can automatically detect SUV, car tire pressure. No need to watch, automatically stop inflation when it reaches a healthy tire pressure value, and will not overcharge. The cigarette lighter takes power and is equipped with 10A fuse, which automatically cuts off power after overload to protect the cigarette lighter.

Portable，intelligence，Air pump，Simplicity，Design，

42 85

wo的天空~想 2020-06-23

It feels very similar to this, Shangshan Design 18 Years Red Dot Award, Come on!
https://www.puxiang.com/galleries/3fc795498d58a80bbd272598c54ad543?favorite=true

HL1072826 2020-03-02

I would like to ask the great god, how does this kind of cylindrical product with no inclination come out of the mold?
Or is the actual product different from the picture, such as how many pieces?

Joesph studio-别开枪。。是我 2020-03-19

I also want to ask this question

三尼的爸爸 2020-04-16

On all sides, the grinding tool is more expensive, and there will be a parting line in the real object. Maybe the effect diagram has not been made.

大兴子 2020-04-29

Great God: Is it coming out on all sides and then pulling the core? Will the cost be very high?

三尼的爸爸 2020-08-18

Yes, the cost of the mold is much higher than the draft angle. The product is a bit long. The inclination draft will affect the shape too much and will be much uglier. You can consider the upper and lower sides of the film, and the middle is drawn, that is, the short side should be arcs and closed to both sides. It is estimated that the inclination of fine lines 1.5 to 2 degrees is about the same, so the change of the shape is small.

大兴子 2020-08-19

Thank you. I 've been taught.

Write a comment